A total of 4 coats of paint are applied to a typical brand new vehicle:
Car paint layer
1. Electrophoretic paint layer: It should be mentioned here that before the electrophoretic paint layer, there is a process of phosphating the sheet metal. The first step is to form an insoluble phosphating film on the surface of the sheet metal, protecting it and improving its corrosion resistance. Electrophoretic paint coating is the process of soaking the entire vehicle body into an electrophoretic pool without any dead spots, rolling or blistering. The primary effect is rust prevention, rust prevention, and is the bottom layer of the vehicle's rust prevention.
Electrophoretic paint layer
2. Intermediate primer layer: In fact, the electrophoretic paint layer is not directly applied to the intermediate primer layer. We know that the entire car, which is simply corroded, must be the chassis, and it is severe. Therefore, the car chassis will be coated with another layer of anti-corrosion paint and two layers of protection, namely "chassis armor". After applying the primer layer, the primary filling effect is to fill in some depressions and small defects, which serve as the isolation layer between the paint layer and the electrophoretic paint layer, which can improve the decorative properties of the paint layer. Of course, there must also be anti-corrosion effects,
Car paint coating
3. Color paint layer: This layer represents the color of car paint, including plain paint and metallic paint (paint containing metal particles).
4. Clear paint layer: Protective paint layer, adding brightness. Strong UV resistance and weather resistance.
The above belongs to the original factory paint coating layer of sedans. Except for the color paint layer, which does not require baking, the other three paint layers need to be baked. People call this coating process "four coatings and three baking", and the baking temperature needs to reach above 170 ℃. It is rumored that some car manufacturers now choose the "three coats and two bakes" method, removing the intermediate primer layer. This car painting process will greatly protect the environment and save energy.
Car paint repair and painting usually involves these 5 layers of paint, but the materials used are different. They are: epoxy primer layer, atomic gray layer, (intermediate primer layer), color paint layer, and clear paint layer. Why do I need to put parentheses on the intermediate primer layer? It is because some irregular ones are replaced with red gray to save costs, and even omitted. Therefore, car paint repairs are cheap but not good. A good job is not cheap.
Article source: Qingyuan Automotive Repair Paint http://www.jinliangxincai.com/
08-25
Common problems with automotive repair paint
Why are the orange lines on the surface of the varnish so heavy after each spray? Why on earth? How can we prevent a decrease?Answer: The thinness of the varnish, the amount of paint produced by the s
06-05
The car repair paint manufacturer told you about the problem with water-based coatings
1. How long does it take for a skilled paint coating technician to master the operation of water paint?Generally, practice and understanding with less than half a sound can be mastered, and proficienc
05-31
Qingyuan Automobile Repair Paint Company tells you the steps for painting
Automotive Painting Process(1) Rust prevention and internal painting of the vehicle body: Depending on the condition of the vehicle body, it will be completed by a sheet metal worker.(2) Polishing and
05-12
Why does car repair paint lack luster?
If there is a lack of gloss on the surface of the originally flat and smooth car paint surface, especially during the process of car paint care, it can be observed under a microscope that the surface